Fathouse's 9 Second Shop EVO -SOLD-
Every project comes to and end and you must move on to new things. That time has come as I look forward to building something I can drag race and make over 1000hp with and have a class to compete in. This car has been great to me, it is very clean and well taken care of. It will be hard to watch her go but in the end I am just ready to move on to something else.
2006 Wicked White EVO 9 RS, 22,914 miles
Fatfab build aluminun rod engine, grp rods, cp 10.5 piston with upgraded wrist pins.
Fatfab built evo 8 head, with kiggly springs, kiggly hla, +.5mm valves, exhaust are inconel. stm 650 cams
Fatfab forward facing turbo kit, pte billet 6766, pte 46mm wg
Fatfab 4.5" garret core based intercooler with 3" in and out.
Fatfab intercooler pipes, upper pipe has twin tial bov
Magnus v5 intake manifold
Wilson fuel rail
Fic 2150 injectors.
Fatfab/spoolinup m&w pro14 ignition system
Buschur racing battery tray
Fatfab twin fuel pump
Aem series one ecu, aem wideband, 5 bar map sensor, ait sensor, 5 bar map for backpressure
Aem wideband gauge
QM 6 leg clutch
Shep racing "dog box" trans. Full ppg gearset, ppg final drive and ppg output shaft. Has a oem 5th gear installed for street driving. Best shifting trans $ can buy!
Shep racing Non acd transfer case. Factory front lsd
AWD motorsports spec d2 coil overs
AWD motorsports aluminum
Buschur racing rear musctach bar
AMS front crossmember
AMS willwood front drag brakes
Car has two sets of wheels if intersted
17" enkie rpf01 with 245/45/17 nitto drags
15" rota slips with 24.5/15 MH slicks
Full interior, no cage, heat, power steering still in tact. Car has been a best of 9.7 @ 152mph http://www.youtube.com/watch?v=BmPKU-CJaPQ with a hurt engine, check out our story about racing it at the DSM/EVO shootout on our homepage at www.fathousefab.com. Scroll down to the second story. Car has a brand new fresh engine, has not been to the track since.